These masts consist of a base for concrete casting, middle sections of 3, 4 or 6m length and, if required, a top section for rotational antennas.
The standard portfolio includes masts with 50, 70 or 90cm width. To facilitate climbing the segments have an additional horizontal bar on one side. The base has a tilt fixture, so that the masts can be assembled on ground before erecting. All parts are hot dip galvanized.
Depending on the local regulations mast up to a height of 10m do not require a building permit (at least in Germany, please check your local regulations). Masts higher than 10m require a building permit and therefore also require static load calculations.
These masts come without a static load calculation. On request and against a nominal fee these calculations can be supplied.
With option 'head segment' useable also for rotateable antenna systems.
Included:
The link antennas, solar panels etc. are fastened to the vertical bars in any height. A head segment for rotating antennas is not included, but available for 50 and 70cm width versions (see below).
(1) Value valid for a dynamic pressure of q0 = 0.80kN/m² (Wind load zone 1 in Germany).
All values valid for free standing masts. When used with additional guying the max. loads are considerably higher.
Combine below segments for any height required.
are no problem. Please download our mast questionaire and send it back to us. We are happy to make you an offer.
| Diese Seite drucken | Diese Seite zu den Favoriten hinzufügen |