Transceiver da Yaesu
FT-7900E: 2m/70cm VHF / UHF Mobiltransceiver
The FT-7900E provides 50 Watts of power on the 144 Mhz band, and 45 Watts on the 430 MHz, and is designed for simplicity of operation along with high performance in the receiver section. The FT-7900E is ideal for the active Ham who has a need for simplex, repeater, or FM satellite operation on both bands, but without the complication of cross-band repeat capability, which is available on our FT-8800R and FT-8900R models. Included is the DTMF microphone MH-48A6J and the separation kit YSK-7800.
Over 1000 Memory Channels
The FT-7900E incredible memory channel capacity includes registers for over 1000 channels, each capable of storing a 6-character Alpha-Numeric label. And the memories may be stored in any of the 20 available memory groups; a particular memory channel may also be stored in multiple groups, if desired.
YSK-7800 Remote Mounting Kit (included!)
Using the optional YSK-7800 Separation Kit, which contains both cabling and a bracket for the remote front panel, you can mount the FT-7900E front panel on the vehicle's dash board, then stow the radio's body under the seat or in some other convenient, out-of-the-way location. The cables are approximately 20 feet (6 m) in length.
One-Touch "Hyper Memory" Operation
Five front panel keys allow complete transceiver configuration status to be stored for convenient one-touch recall. So you can set up favorite frequencies in each operating band, including the receive-only bands, then recall them with a single touch of a button!
High Power Output
Boasting a big 50 Watts of power output on 144 MHz, and 40 Watts on 430 MHz, the FT-7900E also includes provision for three lower power levels, so you never have to use more power than you really need. The power level is stored in regular and Hyper Memory registers, too.
The FT-7900E is no longer available.
|99FREQ||Frequency Extension Please see note!||25.00 €||Aggiungi al carello||In magazzino, spedizione in 1 o 2 giorni. ⓘ|
|Info sui costi di spedizione|
Desktop case for mobile transceivers, including fan
Desktop Case with cooling for various mobile transceivers.
Sometimes even the best equipment can get hot, for example when used in tropical zones or in certain industrial environments. Or you need a fixed place for the mobile transceiver... This is where the desktop case SMB-201 by Yaesu really shines!
The desktop case SMB-201 by Yaesu act as a support and case for various mobile transceivers. Below the radio sits a fan unit to provide cooling, even when the case is installed in narrow spaces with less than perfect ventilation. The SMB-201 includes it's own power supply (SAD-11C, included). The radio is installed with 4 screws into the case, usually the speaker points upwards and is not blocked.
The SMB-201 fit's perfectly for Yaesu radios like the FTM-400D, FT-8900, FT-8800 and FT-7900. Other radios, even from other manufacturers, can be made to fit by using custum made spacers or adaptor plates. Size approx. 146 x 100 x 87mm, weight approx. 700g.
|SMB-201||Yaesu Desktop Case with Fan unit||44.90 €||Aggiungi al carello||In magazzino, spedizione in 1 o 2 giorni. ⓘ|
|Info sui costi di spedizione|
Frequency Extension for RadiosPlease note:
All radios supplied by WiMo normally cover only the amateur bands (transmit wise).
The frequency extension of a radio (TX open) is done on explicit request by the customer.
Amateur Radio transceivers are usually not specified for use outside the amateur bands. In some cases the radio and especially the final amplifier or output filters can be damaged when transmitting outside the amateur bands. These damages are not covered by any warranty.
The manufacturer warranty might be voided in some cases as well.